Occasionally I see Partition 1 as the entry point but all other points here remain the same.ģ. For the attached screen print this dialog was opened under the heading security panel. Should I see "Security Panel" or "Partition 1" in the navigator. Zones and status work fine and show all the zones in my system albeit with some mislabeled doors vs windows etc (I understood this was fixed with the old Domosapiens IT-100 serial driver).Ģ. I have NEVER seen the history tab exposed. Status, Zones and History tabs at top? I do see status and zones off to the left on the iPhone navigator (see attached screen print). My various security windows look similar to what I see in the PDF but.SHOULD I BE ABLE TO SEE:ġ. The PDF document referred to in this thread as well as others shows things that I do not see in Control4 on any of my navigators. I have read all of the forum entries here and other places and as I take another run at this I just need a level set. I am able to arm and disarm the alarm in C4 within my LAN and outside the home as well. I have had Control4 talking to my TL280 (5.03) and HS2032 for some time now since my C4 2.10.2 system has been fully functional for the last 6 mos or so. If you read this thread I had the same problem after following the PDF you used.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |